Robot Coupe R2N - Assembly and Disassembly Instructions; Cutter Bowl Attachment Assembly

R2N and R2N Ultra
Operation Manual
4
II. ASSEMBLY/DISASSEMBLY INSTRUCTIONS
Your Robot Coupe should be placed on a sturdy work surface at a comfortable working height and have a
standard 115 volt power outlet available. Always keep the machine unplugged during assembly and disas-
sembly.
A. CUTTER BOWL ATTACHMENT ASSEMBLY INSTRUCTIONS
Always use caution, and wear cut-
resistant gloves when handling the
blade or the cutting plates.
Always unplug the machine during
assembly and disassembly.
1. Unplug the machine.
2. Place the bowl on the motor base assembly
with the handle located just off center and to the
left as you are facing the front of the unit. Then,
turn the bowl back counterclockwise locking it
in place.
3. Place the blade on the motor shaft. Rotate
the blade until it falls into place on the motor
shaft. The bottom blade should be just off, and
parallel with, the bottom of the bowl.
4. Press the off button in case the machine
was left turned on.
5. Facing the front of the motor base assembly,
place the lid on the bowl with the ramp turned
off center and to the left.
6. Turn the ramp back to the right until it locks
in place over the safety switch rod.
7. DO NOT OPERATE THE MACHINE
UNLESS IT IS PROPERLY AS-
SEMBLED WITH THE LID CENTERED
OVER THE BOWL AND THE RAMP
LOCKED IN PLACE OVER THE
SAFETY SWITCH ROD!
8. ALWAYS REMOVE THE BOWL LID
BEFORE ATTEMPTING TO REMOVE
THE BOWL. OTHERWISE, THE
SAFETY PIN CAN BE BROKEN, PRE-
VENTING MACHINE OPERATION.
LidLid
LidLid
Lid
BladeBlade
BladeBlade
Blade
BowlBowl
BowlBowl
Bowl
MotorMotor
MotorMotor
Motor
BaseBase
BaseBase
Base
AssemblyAssembly
AssemblyAssembly
Assembly
RampRamp
RampRamp
Ramp