• When performing mounting work below the surface to be heated, the manifold must always
be placed above the level of the to be heated surface for venting purposes.
• The manifold must be mounted to the wall in a level position so that the venting point can be
used optimally.
• Always mount the manifold with the supplied rubber silencers to limit noise/vibrations as
much as possible.
• The manifold is exclusively intended for mounting on a wall with the help of the supplied
bolts and plugs. The manifold can also be mounted on a console.
• Ensure that all fasteners are properly tightened. Check if all fasteners are in the right place.
5.2 Tools overview
Tools required for mounting the manifold and the piping:
Mounting preparation
Manifolds Manual 17
Tape measure Pencil / marker Level Brush
Drilling machine Drill Open-end wrench Screwdrivers
Stanley knife
Pipe cutter
copper/steel
Hammer ClothPipe cutter
Allenkey(4mm)
To Next Page
Loading...