Robot Compact PRO - Page 25

Manifolds Manual 23
5. If there is sufcient pressure in the
underoorheatingsystem,youcanventeach
group separately by opening the group valve
and venting through the venting point at the
same time.
6. Close the group valve concerned af-
ter venting is completed and repeat this
procedure for any following groups.
After all groups and manifold have been fully
vented,makesurethatthereissufcientpres-
sure left in the system.
7. Put the plug into the earthed wall socket af-
terllingandventingthesystem.
NOTICE:
Pump must be vented. Check appendices Wilo
Para HU 25/6
Schematic total overview
Installing/mounting