6 For more information, visit global.irobot.com
EN
Cleaning the Front Caster Wheel
Pull firmly on the front wheel module
to remove it from the robot.
Pull firmly on the wheel to remove it
from its housing (see illustration below).
Remove any debris from inside the
wheel cavity.
Reinstall all parts when finished.
Make sure that the wheel clicks
back into place.
Important: A front wheel clogged with
hair and debris could result in damage to
your floor. If the wheel is not spinning freely
after you have cleaned it, please contact
Customer Care.
1
2
3
4
Wheel
Axle
Housing
Washing the bin
Make sure that the bin is completely dry.
Reinsert filter and place bin back in the
robot.
3
Important: Do not wash the filter.
Remove the filter before washing the bin.
Release the bin, remove the filter and
open the bin door.
1
Note: Bin is not dishwasher safe.
Use a coin or small screwdriver to remove
the screw holding the Edge-Sweeping
Brush in place.
Pull to remove the Edge-Sweeping Brush.
Remove any hair or debris, then reinstall
the brush.
Cleaning the Edge-Sweeping Brush
1
2
Rinse the bin using warm water.
2
To Next Page
Loading...
