4. Configure the IP of the Router
There are five Ethernet ports on R2000 Ent Router, including WAN,
ETH1, ETH2, ETH3 and ETH4. The WAN on the router can only be
configured as a WAN port, while ETH1~ETH4 can only be configured as
LAN ports. The ETH1~ETH4 can freely choose from lan0~lan3, but at
least one LAN port must be assigned as lan0. The default settings of
ETH1~ETH4 are lan0 and their default IP are
192.168.0.1/255.255.255.0.
Configure Lan0
Click Interface > LAN > LAN, click lan0’s edit button to configure its
configuration, and modify its IPv4 address and Netmask.
Click lan0’s edit button and configure its parameters in the pop up
window.
When finished, click Submit > Save & Apply for the configuration to
take effect.
Configure Lan1
Click Interface > Ethernet > Ports, click eth1’s edit button, choose lan1
as the assigned port, and click “Submit”.
Note: By default, there is a LAN port (lan0) in the list. To begin adding a
new LAN port (lan1), please configure eth0 or eth1 as lan1 first in
Ethernet > Ports > Port Settings. Otherwise, the operation will be
prompted as “List is full”.
Click Interface > LAN in the homepage, and click the add button.
To Next Page
Loading...
