cobas c 111 Installation Manual
04906900001
INSTALLATION-MANUAL cobas c 111
Version 3.0 Page 16 of 43
5. Delivery, unpacking and set-up of the analyzer
This section describes the state of the analyzer on delivery, how to unpack and set-up the
instrument. The installation and set-up, however, must be performed by a certified per-
son. Please ask your local representative if you have any questions regarding the
installation.
5.1 Delivery
The cobas c 111 analyzer is shipped in a specially designed container.
On delivery, carefully inspect the container. Make a note of any indications of physical
damage and record your observations in the accompanying shipping documents. It is
essential that you report any suspected damage immediately to Roche Diagnostics, and
to the shipping agent, before accepting the unit.
Please also note the Installation Report Feedback Form at the end of this document.
5.1.1 Packing list
The actual version of the analyzer (as delivered), together with a list of the accessories
for your configuration, are detailed in the accompanying packing list. That list specifies
the part numbers and quantities supplied. Please check the items supplied against the
packing list and retain the list for future reference.
5.2 Additional items required
To be able to install and set up the cobas c 111 correctly it is necessary to provide the
following additional items:
Power supply cord, either:
US-Type: Cable Power Mains US STD: No. 25565608001 (rated 15A, 125V.
Cable SJT, 3x16 AWG. Connector type 13V (10A, 250V; 15A, 125V)
or
Euro-Type: Cable Power Mains, No. 25565607001 (3 x 1mm
2
) rated 10A,
250V, or equivalent.
For other country specific power connectors equivalent conditions apply.
See also the pictures 3 & 4 below.
Operator Manual
Ordering of additional material to operate the instrument like cuvette
segments, reagents, calibrator material, QC material, suitable sample tubes,
cleaner etc. Please contact your local sales representative for further details.
To Next Page
Loading...
Need help?
General
