Step 3:
Once you’ve gotten those removed, you will need to remove the inverse screws. These
screws face inward, toward the inside of the machine. There are 2 in the back left and right
corners, and 2 in the front left or right corners. They will most likely require small micro
turns to undo them. I would not recommend fully removing these, as they required a lot
of small turns just to loosen them. You will use your 7mm wrench on these. Undo them just
enough for the panels to come apart.
The two in the back:
4 www.wholelattelove.com
To Next Page
Loading...
