13
RF-AHD35
5 Remove the memory card.
Caution: Do not remove memory cards while the card
reader LED is flashing or blinking.
Formatting a memory card
To format a memory card:
1 Click Start, and then click My Computer.
2 Under Removable Storage, right-click the memory card
icon representing the card type inserted, then click
Format.
3 Type a label name into the label field, if you want to see
the name of your memory card appear under its memory
card icon.
4 Click Start.
5 Click OK in the Format Complete window.
6 Click Close to finish.
Disconnecting the enclosure from your
computer
To disconnect the enclosure from your Windows computer without
shutting it down:
Note: If a drive window is open or the hard drive enclosure is
active, close any associated windows before attempting to
remove the enclosure.
1 Left-click the Hot plug icon (located in the notification area
of taskbar where your usually see the time displayed).
2 Select the drive you want to unplug, then click STOP.
3 When Windows notifies you that it is safe to do so,
unplug the enclosure from your computer.
To disconnect the enclosure from your Macintosh computer without
shutting it down:
1 Drag the USB icon into the TRASH.
2 Unplug the enclosure.
RF-AHD35_09-0774_MAN_ENG_V3.fm Page 13 Friday, September 25, 2009 6:51 AM
To Next Page
Loading...
