RocketFish RF-TVMLPT01 User Manual

Tools you will need:
• Stud nder
• Awl
• Level
• Pencil
Package contents
A TV bracket (1)
B Wall plate (1)
M4 bag
C M4 x 12 mm screws (4)
D M4 x 30 mm screws (4)
E M4 washers (4)
F M4 spacers (4)
Miscellaneous bag
G Locking screw (1)
H 5/32 in. hex key (1)
Lag bolt bag
I 5/16 in. x 2¾ in. lag bolts (2)
J Concrete anchors (2)
Thank you for choosing the
Rocketsh RF-TVMLPT01.
The RF-TVMLPT01 TV mount
is designed to support
a TV weighing up to
50 lbs. (22.7 kg).
• Hammer (Concrete Only)
• Tape measure
• Power drill
• 3/16 in. wood drill bit
• 3/8 in. masonry
drill bit(Concrete Only)
• Socket wrench with ½ in. socket
or adjustable wrench
• Phillips screwdriver
QUICK SETUP GUIDE
RF-TVMLPT01
M4 x 12mm
in.
M4 bag
Miscellaneous bag
Lag bolt bag
A
B
C
D
G
H
I
J
1 Install locking screw
Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H).
Do not screw in more than three or four turns.
2 Attach the TV bracket
Option 1: If the back of the TV is at
Align the TV bracket (A) with the mounting screw holes
on the back of the TV. Place the washers (E) over
the screw holes on the TV bracket.
Note: If the hole pattern on your TV is 75 mm x 75 mm,
do not use the washers. Insert the screws (C) though
the screw holes and tighten.
G
H
A
E
C
With washers
M4 x 30mm
E
F
M4
M4
A
C
Without washers
Option 2: If the back of the TV is curved or to make room for cables
Attach the TV bracket [A] to the back of the TV using the washers (E), the spacers (F), and the screws (D).
Note: If the hole pattern on your TV is 75mm x 75mm the washers(E) will not be used.
A
E
F
D
A
D
F
With washers
Without washers

RocketFish RF-TVMLPT01 Specifications

General

Brand	RocketFish
Model	RF-TVMLPT01
Category	TV Mount
Language	English

Summary

Install TV Bracket and Locking Screw

Install Locking Screw

Install the TV bracket locking screw into the TV bracket using the hex key.

Attach TV Bracket to TV

Attach the TV bracket to the TV back using screws, washers, and spacers as needed for flat or curved screens.

Install Wall Plate

Install Wall Plate to Wood Stud

Secure the wall plate to a wood stud using lag bolts after drilling pilot holes and verifying stud location.

Install Wall Plate to Concrete Wall

Mount the wall plate to concrete walls using anchors and lag bolts, ensuring flush seating and avoiding mortar.

Mount TV and Adjust Settings

Mount TV to Wall

Slide the TV/bracket assembly down over the wall plate tabs and tighten the locking screw.

Adjust Tilt Angle

Adjust the screen tilt angle and tension using the hex key or hand for desired viewing position.

Important Safety Instructions and Warranty

Safety Precautions

Review crucial safety warnings regarding installation, weight limits, and potential hazards.