RocketFish RF-WSW312 User Manual

14
1 Wireless Sender - Press and hold the pairing button for
more than two seconds, then release it. The Wireless
Sender enters pairing mode.
2 Wireless Receiver - Press and hold the pairing button for
more than two seconds, then release it. The Wireless
Receiver enters pairing mode.
The Wireless Sender and Wireless Receiver will be paired
within 10 seconds and will reconnect automatically if turned
off and on.
•Standby mode
• The system will go into standby mode if no audio input
signal is detected for more than five minutes. The LED
indicators on the Wireless Sender and Wireless Receiver
turn from blue to red.
• Input signal auto selection
• On the Wireless Receiver, the subwoofer input signal is
always used when available. When the subwoofer input
signal is unavailable for 15 seconds, and stereo input is
available, the stereo input will be used.
To listen to the subwoofer audio:
1 Power on the system. Make sure that the Wireless Sender
and Wireless Receiver are paired.
2 Turn on your amplifier, then play the audio or video source
through your amplifier.
12-1005_RF-WSW312_MAN_V1_EN.fm Page 14 Friday, October 12, 2012 12:13 PM

RocketFish RF-WSW312 Specifications

General

Brand	RocketFish
Model	RF-WSW312
Category	Subwoofer
Language	English