15
RF-WSW312
Troubleshooting
Please read this User Guide carefully before using your
universal wireless subwoofer kit. Check this list for a possible
troubleshooting solution before calling for service.
Specifications
Wireless Sender
Problem Solution
No sound
• Make sure that the AC adapters are connected to the Wireless Sender and the
Wireless Receiver.
• Make sure that all of the cables are connected correctly. Check to see if the LEDs
light up on the front of both the Wireless Sender and Wireless Receiver units. If the
LEDs are lit solid blue, the communication is working correctly and audio
connecting wires and the amplifier operation should be checked. If the LEDs are
flashing, refer to the “No communication between the Wireless Sender and
Wireless Receiver” section below.
Sound interference
• Move the Wireless Sender and Wireless Receiver slowly to find the best reception
position for your system.
• Shorten the distance between your Wireless Sender and Wireless Receiver. The
maximum distance is 45 feet.
• Check to determine if there are any obvious radio frequency interference sources
near your system.
No communication
between the Wireless
Sender and Wireless
Receiver.
• Make sure that the power cables are connected correctly.
• When the Wireless Sender and Wireless Receiver are connected to power, the front
panel LEDs should light. If they are solid blue, a communication link has been
successfully established between the units. If they are flashing on one or both
units, press and hold the CONNECT button on either the Wireless Sender or
Wireless Receiver for two seconds. This will put the unit into the “connection
mode” for about 30 seconds. During this period the CONNECT button on the other
unit must also be pressed for two seconds so that it will also enter “connection
mode.” The system proceeds with the connection process between the Wireless
Sender and Wireless Receiver. While in “connection mode,” the LED indicators blink
at a faster rate. When an active link is established between the Wireless Sender
and Wireless Receiver, the LED indicators will be solid blue and will not blink.
Audio Input
• Maximum audio input signal: 2 V RMS
Audio Output: Wireless
• 16-bit, 48 KHz uncompressed
Supply voltage
•5V
12-1005_RF-WSW312_MAN_V1_EN.fm Page 15 Friday, October 12, 2012 12:13 PM
To Next Page
Loading...
Need help?
General