Need help?Do you have a question about the Rockford Fosgate 550X and is the answer not in the manual?
General| Power Output | 550 Watts |
|---|---|
| Channels | 2 |
| Frequency Response | 20 Hz - 20 kHz |
| Dimensions | 10.5" x 9.5" x 2.25" |
| Input Sensitivity | 200mV - 4V |
| THD at Rated Power | <0.05% |
| Signal to Noise Ratio | >100 dB |
| Crossover Slope | 12 dB/octave |
| Minimum Impedance | 2 ohms |
| RMS Power (2 ohms) | 275 Watts x 2 |
| Bridged RMS Power (4 ohms) | 550 Watts x 1 |
| Bass Boost | 0-18dB |
Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss.
Important instructions regarding warnings and cautions for installation and use.
Lists the components included in the amplifier package.
Details on gold-plated power and speaker connection terminals for optimal signal transfer.
Information on RCA input and pass-thru jacks for audio signal connection and daisy-chaining.
Explanation of variable crossover filters and gain adjustments for sound tuning.
Overview of LED indicators, remote terminal, heatsink, and input switching.
Lists necessary tools and pre-installation checks for amplifier setup.
Guidance on selecting optimal and warranty-safe mounting positions for the amplifier.
Recommendations for mounting the amplifier vertically or on the trunk floor for cooling.
Guidelines for mounting in the passenger compartment with adequate airflow.
Advice on checking vehicle's electrical system capacity for amplifier load.
Detailed steps and precautions for connecting power, ground, and signal wires.
Diagram illustrating proper power, ground, and speaker connections to the amplifier.
Instructions for connecting the amplifier using a 2-channel source unit setup.
Instructions for connecting the amplifier using a 3-channel source unit setup.
Instructions for connecting the amplifier using a 4-channel source unit setup.
Explanation of passive crossover circuits and their use with amplifier and speakers.
Guide on mounting and installing the remote Punch Bass control knob.
Procedure for setting the amplifier's input gain to match the source unit output.
Steps for setting the HP, AP, or LP crossover points for front and rear channels.
Steps to verify correct wiring and power connections for amplifier operation.
Steps to diagnose issues with audio signal input and amplifier output.
Methods to eliminate or reduce turn-on pop noise from the amplifier.
Solutions for mitigating engine noise interference in the audio system.
To Next Page