Need help?Do you have a question about the Rockford Fosgate Power T400-4 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | > 100 dB |
| Topology | Class AB |
| RMS Power Output (4 Ohm) | 50 Watts x 4 |
| RMS Power Output (2 Ohm) | 100 Watts x 4 |
| Bridged RMS Power Output (4 Ohm) | 200 Watts x 2 |
| Input Sensitivity | 150 mV - 4 V |
| Crossover | 12dB/Octave |
| Bass Boost | 0dB / +6dB / +12dB @ 45Hz |
Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss. Use common sense and practice safe sound.
Alerts users to important instructions for preventing injury and unit damage. Emphasizes reading the manual and professional installation if unsure.
Describes Power, Thermal, Protect LEDs and details Speaker, Power, Ground, and Remote connection terminals.
Covers Punch EQ, Crossover controls, Gain adjustment, and optional Remote Punch EQ for system tuning.
Explains RCA inputs, Pass-Thru jacks, and the 2/4 Channel Switch functionality.
Provides guidance on suitable mounting locations for the amplifier, excluding the engine compartment.
Explains the increased load on the vehicle's electrical system and recommends checks and upgrades.
Provides step-by-step instructions and cautions for wiring the amplifier, including power, ground, and remote connections.
Details how to connect RCA cables for signal input and mentions the 2/4 CH. SWITCH function.
Diagram illustrating the wiring setup for a mono bridged audio configuration.
Diagram illustrating the wiring setup for a stereo bridged audio configuration.
Instructions for quick installation and operation of the optional remote EQ unit.
Explains the function of the Punch EQ for bass and treble boost based on crossover settings.
Guide on setting the crossover switch (HP, AP, LP) and adjusting the crossover frequency knob.
Provides procedures to diagnose and resolve issues like no power, protect/thermal lights, no audio output, turn-on pop, and engine noise.
Instructions on how to get service under warranty, including contact information and obtaining an RA#.
Information about installation assistance available through RFTECH and contact details for Rockford Fosgate.
To Next Page