Need help?Do you have a question about the Rockford Fosgate Punch P250.2 and is the answer not in the manual?
General| Number of Channels | 2 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Fuse Rating | 25A |
| Rated Power (2 Ohms) | 125W x 2 |
| Bridged Power (4 Ohms) | 250W x 1 |
| Signal-to-Noise Ratio | 80dB |
| Crossover | Variable High Pass / Low Pass |
Important safety warnings and precautions for installation.
Lists the items included in the amplifier package.
Blue LED indicating the unit is turned on.
Red LED indicating thermal protection stage.
Yellow LED indicating short circuit or low impedance.
Dissipates heat generated by the amplifier's circuitry.
Heavy-duty connectors for speaker wire.
Low-frequency boost control for bass adjustment.
Adjusts input gain to match source unit output levels.
Built-in filter for HP, AP, or LP operation.
Industry-standard jacks for signal level input.
Allows daisy-chaining additional amplifiers.
Terminal for remote turn-on/turn-off control.
Connectors for power and ground wires.
ATC fuses for protection and failure replacement.
Lists tools needed and general advice for installation.
Guidance on where to mount the amplifier for optimal cooling and warranty.
Importance of checking vehicle's electrical system for amplifier load.
Detailed steps for routing wires, connecting power, ground, and signal.
Instructions for mounting and using the remote bass control.
Procedure for setting the amplifier's input gain level for optimal performance.
How to set the crossover point for different filtering modes.
Verifies correct wiring and power supply for the amplifier.
Diagnoses issues related to protect/thermal indicator lights.
Troubleshoots problems with no audio output from the amplifier.
Addresses noise issues when turning the amplifier on or off.
Solves problems related to engine noise interference in the audio signal.
To Next Page