Need help?Do you have a question about the Rockford Fosgate Punch P1200.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Frequency Response Tolerance | ±1 dB |
| Input Sensitivity | 200 mV - 4 V |
| Bass Boost | 0 to +18 dB |
| Fuse Rating | 30A x 2 |
| Low Pass Crossover | 50 Hz - 250 Hz |
| Dimensions | 2.88" x 10.25" x 13.75" |
| THD at Rated Power | <1% |
| Signal to Noise Ratio | >90 dB |
| Crossover | Variable |
| Signal-to-Noise Ratio | >90 dB |
Safety advice on protecting hearing from high sound pressure levels.
Blue LED indicating when the unit is turned on.
Red LED indicating thermal protection stage, causing shutdown.
Yellow LED indicating short circuit or low impedance detection.
Dissipates heat generated by the amplifier's circuitry.
Heavy duty, nickel-plated connectors for speaker wire.
Boosts low frequencies for road noise, adjustable bass enhancement.
Adjusts input gain to match source unit output levels.
Built-in filter for High-Pass, All Pass, or Low-Pass operation.
Standard jacks for easy signal level input connection.
Allows daisy-chaining additional amplifiers without extra RCA cables.
Important factors and tools needed before installing the amplifier.
Guidance on where to mount the amplifier for optimal performance and warranty.
Recommendations for vehicle electrical system to handle amplifier load.
Step-by-step instructions for connecting the amplifier's wiring.
How to mount and install the remote bass control unit.
Procedure for setting the amplifier's input gain for optimal sound.
How to set the crossover frequency for desired audio filtering.
Steps to verify all connections are correctly made to the amplifier.
Diagnosing issues when Protect or Thermal LEDs are illuminated.
Steps to diagnose lack of audio output from the amplifier.
Troubleshooting methods for loud pops when turning the system on/off.
Solutions for reducing engine-related noise in the audio system.
To Next Page