Need help?Do you have a question about the Rockford Fosgate Punch 800.2 and is the answer not in the manual?
General| Brand | Rockford Fosgate |
|---|---|
| Model | Punch 800.2 |
| Category | Car Amplifier |
| Language | English |
Power output under dynamic conditions at 14.4 volts.
RMS power output at 13.8 volts with specified THD+N.
Specifies signal to noise ratio and crossover slope/frequency.
Details physical dimensions, frequency response, damping factor, slew rate, and input sensitivity.
Lists fuse requirements and input impedance for various models.
Lists accessories included with the Punch 2-channel amplifiers.
Compares internal circuitry like TRANS-ANA, MEHSA, TOPAZ, and DSM across models.
Lists and compares features like heatsink, inputs, terminals, bass, and crossover.
Diagram and labels for Punch 100 amplifier terminals and controls.
Diagrams and labels for Punch 120/160 amplifier terminals and controls.
Diagrams and labels for Punch 250-800 amplifier terminals and controls.
Explains the function of heatsink, terminals, inputs, gain, bass, crossover, and LED.
Lists tools and materials needed for amplifier installation.
Provides essential safety precautions before and during installation.
Advises on optimal placement for cooling and performance in vehicle locations.
Recommends checking the vehicle's electrical system capacity for the amplifier load.
Instructions on routing signal and power wires to prevent noise.
Details connecting power, ground, and remote turn-on wires.
Instructions for connecting speakers and performing a final system check.
Explains how to connect audio sources via RCA or high-level inputs.
Illustrates power connection setup for Punch 100/120/160.
Shows wiring for bridged/mono operation of Punch 100/120/160.
Wiring diagrams for 2-channel and 3-channel speaker configurations on Punch 250-800.
Specific power connection diagram and notes for the Punch 800 amplifier.
Illustrates a typical 2-way audio system setup with components.
Shows how to connect the Remote Punch Bass control to the amplifier.
Steps to check for proper power, ground, and remote turn-on connections.
Steps to diagnose issues with audio signal and speaker output.
Solutions for amplifier turn-on pop noise issues.
Steps to resolve excess engine noise interference in the audio system.
Outlines what is covered and not covered by the product warranty.
Instructions for obtaining warranty service and repair addresses.
To Next Page