RockNRoller Multi-Cart R64C User Manual (English)

To Next Page

R6RT Model Specifications

Your RocknRoller Multi-Cart shipping box should

contain a frame and the following parts:

Recommended Tools For Assembly

Length (Compact) 28” 4 x ½” at washers

Length (Extended) 42.5” 4 x ½” lock nuts

Channel Lock Pliers

(not included)

Width (Frame Bed) 12.5” 1 x 1” (25 mm) square plastic endplug (spare)

Width (Rear Casters) 18” 1 x ¾” (20 mm) square plastic endplug (spare)

Height (Folded) 9.5” 4 x 4”x 1” (100 mm x 25 mm) stem casters

Height (Unfolded) 33.25” 1 x Flat Wrench

Front Casters 4” x 1” 1 x Assembly/instruction sheet

Rear Casters 8” x 2.5” 2 x 570 mm Non-skid Tape (optional - place where preferred)

Weight 22 lbs.

Load Capacity 500 lbs.

Installing Swivel Casters

Attach swivel casters as shown. While tightening lock nuts, grip bearing cap with channel lock pliers or pipe wrench to prevent

threaded stem from turning. Tighten lock nuts rmly, but not excessively tight. Check lock nut tightness on caster stems periodically.

Need help?

Do you have a question about the RockNRoller Multi-Cart R64C and is the answer not in the manual?

RockNRoller Multi-Cart R64C Specifications

General

Lists necessary tools for assembling the RocknRoller Multi-Cart.

Details the process of attaching swivel casters using provided parts and tools.

Instructions on how to extend the cart's frame by loosening wingbolts and engaging stops.

Instructions on how to raise the cart's foldable sides by pressing a release cable.

Describes various configurations like Short Furniture Dolly, Storage-Transport, and Platform Cart.