RockNRoller R2RT-RD - User Manual

R2RT Model Specifications
Your RocknRoller Multi-Cart shipping box should
contain a frame and the following parts:
Recommended Tools For Assembly
Length (Compact) 26” 2 x ½” at washers
Length (Extended) 39” 2 x ½” lock nuts
Channel Lock Pliers
(not included)
Width (Frame Bed) 11” 1 x 1” (25 mm) square plastic endplugs
Width (Rear Wheels) 14” 1 x ¾” (20 mm) square plastic endplugs
Height (Folded) 6.5” 2 x 1⁄8” x 1” cotter pins
Height (Unfolded) 30.75” 2 x 16 mm at washer
Front Casters 4” x1” 2 x 6”x 1.5” (150 mm x 37 mm) wheels
Rear Wheels 6” x 1.5” 2 x 4”x 1” (100 mm x 25 mm) stem casters
Weight 15.4 lbs. 1 x Flat Wrench
Load Capacity 350 lbs. 1 x Assembly/instruction sheet
2 x 530 mm Non-skid Tape
1. Installing Rear Wheels
Gently slide wheel over axle as shown.
Do not force wheels onto axle. It is
recommended to lubricate axles with light
grease before installing. Install cotter pins
and bend ends outward.
2. Installing Front Swivel Casters
Attach front swivel casters as shown. While tightening lock nuts, grip
bearing cap with channel lock pliers or pipe wrench to prevent threaded
stem from turning. Tighten lock nuts rmly, but not excessively tight.
Check lock nut tightness on caster stems periodically.

Summary

Assembly Instructions

Installing Rear Wheels

Guide for attaching rear wheels to the Multi-Cart axle with cotter pins.

Installing Front Swivel Casters

Instructions for attaching front swivel casters, including tool use and tightening advice.

Operating Your Rock N Roller Multi-Cart

Extending Frame Operation

Steps to extend the frame by loosening wingbolts and pulling up the frame.

Raising Foldable Sides

Instructions for raising foldable sides by pressing release cable and lifting.

Multi-Cart Configurations

Describes various configurations: furniture dolly, luggage cart, platform cart, and hi-stacker modes.

RocknRoller Multi-Cart R2 RT Accessories

RockNRoller R2RT-RD Specifications

General

Frame Type	Folding
Frame Material	Steel
Wheel Type	Pneumatic
Foldable	Yes
Handle Type	Telescoping
Material	Steel
Collapsed Size	32 x 20 x 14 inches