Need help?Do you have a question about the Rockville SS8P and is the answer not in the manual?
General| Size | 8 inches |
|---|---|
| Frequency Response | 20Hz - 150Hz |
| Impedance | 4 Ohms |
| S/N Ratio | >90dB |
| Fuse Rating | 15A |
| Enclosure Type | Sealed |
| Type | Active Subwoofer |
| Voice Coil | 1.5" |
| THD | <1% |
| Filter | 50Hz - 150Hz |
| Bass Boost | 0 - 12dB @ 45Hz |
Avoid electric shock by not opening the unit; refer service to authorized centers.
Keep unit dry and ensure proper ventilation to prevent damage or malfunction.
Explanations of Power/Protect LEDs, Phase Shift, Auto Power-on, filters, gain, and ports.
Details on impedance, dimensions, frequency response, sensitivity, and input levels.
Explains RCA input wiring, preferred for audio performance, requires 6-12 ft RCA cable.
For systems lacking RCA outputs; splice to headunit's speaker outputs, observe polarity.
Connect ground and +12V to battery when Auto Power-On switch is in the 'ON' position.
Connect ground, +12V, and remote turn-on wire to headunit when Auto Power-On is 'OFF'.
Check ground, +12V, remote turn-on voltage, and all fuses; reset protection LED if needed.
Verify fuses, ground connection, remote turn-on voltage, and RCA cable connections.
Address low output, high hiss, squealing, or distorted sound by checking gain and connections.
Eliminate static or alternator whine by routing RCA cables away from vehicle wiring and checking grounds.
To Next Page
