Rockwell Automation Publication 2711R-IN001B-EN-P - September 2022 17
PanelView 800 HMI Terminals Installation Instructions
Battery Removal
The battery is on the back of the terminals. No special tools are required to remove the battery cover, but a flat-
tip screwdriver may be required to remove the battery.
WARN ING: To avoid the danger of explosion, only replace the battery with 2711P-RY2032 or a
manufacturer’s equivalent such as the Matsushita or Duracell DL2032.
For safety information on the handling of lithium batteries, see the Guidelines for Handling
Lithium Batteries, publication AG 5-4
.
Do not dispose of battery in a fire or incinerator. Dispose of used batteries in accordance
with local regulations.
WARN ING: When you connect or disconnect the battery an electrical arc can occur. This could
cause an explosion in hazardous location installations. Be sure that the area is nonhazardous
before proceeding.
For safety information on the handling of lithium batteries, including handling and disposal
of leaking batteries, see the Guidelines for Handling Lithium Batteries, publication AG 5-4.
This product contains a lithium battery that may need to be replaced during the life of the
product. At the end of its life, the battery contained in this product should be collected
separately from any unsorted municipal waste. The collection and recycling of batteries
helps protect the environment and contributes to the conservation of natural resources as
valuable materials are received.
ATTENTION: Battery contains Perchlorate Material – Special handling may apply.
See www.dtsc.ca.gov/perchlorate.
This perchlorate warning only applies to primary Lithium Manganese Dioxide (LiMnO2) cells
or batteries, and products containing these cells or batteries, sold or distributed in
California, USA.
Battery cover
This equipment is sensitive to electrostatic discharge (ESD).
Follow ESD prevention guidelines when handling this equipment.
To Next Page
Loading...
Need help?
General
