Rocstor BLAZER B9 - Connecting the Drive

Page \ 3
ROCSTOR | Blazer B9 quick installation guide
Connecting the Drive
1. Turn ON your computer and wait until it fully boots up to load
all programs.
2. Using only one interface cable at a time, select the interface port you wish to use on your computer. When using
FireWire, connect one end of the FireWire cable to the appropriate FireWire port (FW800 or FW400) of your computer
and then the other end to the FireWire port in the Blazer. When using USB, connect the USB cable to the USB ports of
your computer (or via Power Hub that is connected to your computer) and then the other end to the USB port in the
Blazer. Upon connection, a Blue light on the Blazer drive will turn ON
4. The Hard drive is preformatted for Plug-and-Play operation. After a few seconds a Rocstor HD icon will show on
“My Computer” folder under the Windows OS. Under the Mac OS, the Rocstor HD icon will appear on the “Desktop.”
5. Click (double click) on the Rocstor HD icon to access the drive.
* You may also refer to the Rocstor website to view or download a full version of the BLAZER B9 manual. www.ROCSTOR.com
or
or
FW800
FW400
USB 2.0
FireWire
400
USB Optional
Power
FireWire
800