Rocstor® Rocsecure® DE51 [5]
Please read the Safety Notices and Limited Warranty information in this Manual and on the
Rocstor website (www.rocstor.com) for further details.
FCC-B RADIO FREQUENCY INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This equipment
generates radio frequency energy, and if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications.
PRECAUTIONS FOR THE RAID SYSTEM
The main circuit board of the RAID System is susceptible to static electricity. Proper grounding is
required to prevent electrical damage to the RAID System unit or other connected devices, including the host
computer. Always place the RAID System unit on a smooth surface and avoid all dramatic movement,
vibration and percussion.
Any loss, corruption, or destruction of data is the sole responsibility of the owner/user(s). Under no
circumstances will the manufacturer be held liable for the recovery, restoration, loss … of any data.
Installation of MSU Software in the host computer is required for proper operation.
Do NOT allow water to enter the RAID System unit.
Installation of additional equipment in the host computer may be required. Visit our website to download
the latest product information updates.
Do NOT attempt to service this unit yourself. Disassembling the RAID System’s inner parts will expose you
to dangerous voltages or other hazards.
Do NOT block the ventilation. Proper airflow is required to ensure reliable operation and to prevent
overheating.
Do NOT place the RAID System close to magnetic devices (such as a mobile phone), high-voltage devices
(such as a hair dryer), or near a heat source (such as on the dashboard of a car or any place where it will be
exposed to direct sunlight).
Do unplug the RAID System unit from the electrical outlet when not in use to provide an ecological friendly
environment.
Use only the power supply cable provided with the RAID System unit.
Any loss, corruption, or destruction of data is the sole responsibility of the user of the RAID System.
To Next Page
Loading...