RODEC MX180 MKII RODEC MX34
4
Volume control for DJ mike
11) Master output fader
Volume controls final output of mixer towards slave or integrated amplifers.
12) Equalizer controls
This is used to regulate the degree of treble, middle and bass in the sound.
13) Talk-over control
Variable stage gain control level music suppression.
14) Level adjuster
Mike level for accurate adjustment of different types of microphones.
15) DJ micro input
Microphone input with priority on the input on the back of the set.
16) Level adjuster
These controls are used to adjust input levels of the different inputs.
17) Input selector
This switch is used to select the input signal: PHONO/AUX/CD/DAT/MD or
MICROPHONE.
18) Remote control switch option
This switch is used to start and/or stop any connected apparatus from the mixing panel.
19) Equalizer
Triple tone control for DJ microphone.
20) Pan Mic
Panoramic control only for microphone input. With this button you can place the mike signal
somewhere between left and right.
21) Record Select
This switch is used to make recordings with or without the DJ microphone.
+ DJ MIC : in this position you add the signal of the DJ mike to the music.
- DJ MIC : in this position you record only the signal from channel 1 - 4 (8).
This switch has no influence on the master outputs.
CONNECTIONS
A) PHONO input
Phono input with a sensitivity of 2mV and build in RIAA correction.
B) Ground
If the recordplayer has a ground wire, connect it to the ground terminal.
C) MD(VIDEO)/AUX input
Input with a sensitivity of 220mV. To connect different apparatuses as a tuner, tape
recorder, mini disc, cassette recorder or (HIFI) video recorder.
D) CD/DAT input
Input for compact disc players and digital tape recording.
E) Micro input
To Next Page
Loading...
