Need help?Do you have a question about the RoDEK R4100A and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 100W x 4 |
| RMS Power @ 2 Ohms | 150W x 4 |
| RMS Power Bridged @ 4 Ohms | 300W x 2 |
| THD | <0.05% |
| Input Sensitivity | 200mV - 6V |
| Frequency Response | 10Hz - 30kHz |
| Bass Boost | 0dB - 18dB |
Guidance on selecting the optimal placement for the amplifier, considering ventilation and accessibility.
Instructions for running and connecting RCA audio signal and remote switching cables.
Details on connecting speaker wires to the amplifier terminals and wire gauge recommendations.
Guidance on properly connecting the main power supply cables, including fuse placement.
Specifies the minimum impedance requirements for amplifier operation and potential damage risks.
Explains how to set the operation mode (Fullrange, Highpass, Bandpass) for each channel pair.
Provides recommended high-pass crossover frequencies for satellite speaker systems.
Instructions for setting the crossover frequencies for kickbass systems using bandpass mode.
Guidance on setting crossover frequencies for subwoofer systems in bandpass mode.
Details on setting input gain controls for optimal signal-to-noise ratio and headroom.
Explains how to adjust the phase shift control for optimal sound staging and bass precision.
Lists conditions and circumstances not covered by the product warranty.
To Next Page
