18
• Do not smoke while handling fuel.
• Add fuel before starting the engine.
• Loosen fuel cap slowly.
• Replace all fuel tank and container caps securely.
• Wipe spilled fuel from the unit.
• If fuel is spilled do not start the engine.
• Never attempt to burn off spilled fuel under any circumstances.
• Before storing allow the engine to cool.
• Store fuel in a cool well vantilated area.
• Store fuel in contaniers.
• Empty fuel tank and restrain the unit from moving.
• When servincing use only identical replacement parts.
• Make sure minimum clearance.
• Save these instructions.
• Never operate the product without the safety guard in place and in good condition.
• Keep the working area free from wires nails metalic cable glass Stones and debris.
• Do not cut against hard objects.
• Do not operate with the tool in areas with sands and stones.
• Use both hands while operating.
•Hold the tool below your waist while operating.
• Keep your fingers and other body parts away from cutting blade.
INSTALLATION
INSTALLING PLASTIC SHIELD
Install the safety cover on the shaft with the safety cover bracket and the screws provided.
Tighten the screws after setting the safety cover at the appropriate position.
FLEXIBLE SHAFT AND PROP SHAFT ASSEMBLY INSTALLATION
To Next Page