35
Audio Control `
Normally you do not need to make any changes to these audio menus.
Menu item Value Explanation
Master Volume ` Off, -31.25 +6.25
Change the volume of the entire organ. Caution: this value is set by your Rodgers
technician. Changing this value to a higher number may result in distortion. Note: if
the console has controls engraved MAIN OFF, ANT ON, ALT AUDIO A, or ALT AUDIO
B and they are active (illuminated), the Master Volume setting may change per
active control.
Main Volume
Off, -31.25
+6.25
Changes the main volume of the device connected to the Aux Inputs
of the console. Caution: this value is set by your Rodgers technician.
Changing this value to a higher number may result in distortion.
Main Balance -10 +10
Determines the stereo balance. -10 is extremely left, 0 is center, +10
is extremely right.
Ant Volume
Off, -31.25
+6.25
If Antiphonal speakers are installed, this changes the antiphonal
volume of the device connected to the Aux Inputs of the console.
Caution: this value is set by your Rodgers technician. Changing this
value to a higher number may result in distortion.
Ant Balance -10 +10
Determines the stereo balance. -10 is extremely left, 0 is center, +10
is extremely right.
Treble -14 +14
The treble EQ of the device connected to the Aux Inputs of the
console.
Bass -14 +14
The treble EQ of the device connected to the Aux Inputs of the
console.
Amb Lvl
Off, -31.25
+6.25
Changes the Ambience Level (sensitivity to the organ’s Room
Modeling settings) of the device connected to the Aux Inputs of the
console.
Gain Boost 0 +18.5
Changes the Gain Boost of the device connected to the Aux Inputs of
the console. Caution: this value is set by your Rodgers technician.
Changing this value to a higher number may result in distortion.
SW
Yes,
No
Sends the audio of the Aux In device to the Swell speakers.*
GT
Yes,
No
Sends the audio of the Aux In device to the Great speakers.*
CH
Yes,
No
Sends the audio of the Aux In device to the Choir speakers.*
SO
Yes,
No
Sends the audio of the Aux In device to the Solo speakers, if installed.*
ASN
Yes,
No
Sends the audio of the Aux In device to the Assignable speakers, if installed.*
ANT
Yes,
No
Sends the audio of the Aux In device to the Antiphonal speakers, if installed.*
AMB
Yes,
No
Sends the audio of the Aux In device to the Ambient speakers, if installed.*
RVB
Yes,
No
Sends the audio of the Aux In device to the Room Modeling parameter.*
Aux Inputs
`
Send
to
* Note: if the console has controls engraved MAIN OFF, ANT ON, ALT AUDIO A,
or ALT AUDIO B and they are active (illuminated), this setting may change per
active control.
Gain
Boost
0 +18.5
Affects the Line Out L/R audio signal
Rotate
the
Select
Knob
Line Out `
Mode
Stereo,
Mono
Affects the Line Out L/R audio signal
To Next Page
Loading...
