EN
52
Enable limit switches
N.B.: This parameter is visible only if $ .
No limit switch installed.
Gate open limit switches installed.
'SRƼKYVMRKWIRWMRKIHKI COS1
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when opening.
Contact with 8k2 resistor. The gate reverses only when opening.
NC contact (normally closed). The gate always reverses.
Contact with 8k2 resistor. The gate always reverses.
'SRƼKYVMRKWIRWMRKIHKI COS2
N.B.: This parameter is not visible if $and .
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when closing.
Contact with 8k2 resistor. The gate reverses only when closing.
NC contact (normally closed). The gate always reverses.
Contact with 8k2 resistor. The gate always reverses.
'SRƼKYVMRKVEHMSGLERRIP46
'SRƼKYVMRKVEHMSGLERRIP46
STEP MODE.
4%68-%034)2-2+
OPENING
CLOSING.
STOP.
'SYVXIW]PMKLX8LISYXTYX'36MWQEREKIHJVSQXLIVIQSXIGSRXVSP8LIPMKLXVIQEMRWPMXEWPSRKEWXLI
remote control is active. The parameter is ignored.
'SYVXIW]PMKLX323**448LISYXTYX'36MWQEREKIHJVSQXLIVIQSXIGSRXVSP
The remote control turns the courtesy light on and off. The parameter is ignored.
78)413()[MXLGSRƼVQEXMSRJSVWEJIX]
(1)
4%68-%034)2-2+[MXLGSRƼVQEXMSRJSVWEJIX]
(1)
34)2-2+[MXLGSRƼVQEXMSRJSVWEJIX]
(1)
'03796)[MXLGSRƼVQEXMSRJSVWEJIX]
(1)
(1)
8STVIZIRXKEXIQERSIYZVIWGEYWIHF]EGGMHIRXEPP]TVIWWMRKEVIQSXIGSRXVSPFYXXSRGSRƼVQEXMSRMWVIUYMVIHXSIREFPIXLIGSQ
mand. Example: parameters and set:
• 4VIWWMRKXLI',%FYXXSRSRXLIVIQSXIGSRXVSPWIPIGXWXLIWXITQSHIJYRGXMSR[LMGL QYWX FIGSRƼVQIH[MXLMRWIGSRHWF]
TVIWWMRK',&SRXLIVIQSXIGSRXVSP4VIWW',&XSEGXMZEXITEVXMEPSTIRMRK
'SRƼKYVMRKƽEWLMRKPMKLXJVIUYIRG]
8LIJVIUYIRG]MWWIXIPIGXVSRMGEPP]JVSQXLIƽEWLMRKPMKLXYRMX
7PS[ƽEWL
0MKLXƽEWLIWWPS[P][LIRKEXISTIRWVETMHP][LIRKEXIGPSWIW
Selecting courtesy light mode
Disabled.
4907)8LIGSYVXIW]PMKLXMPPYQMREXIWFVMIƽ]EXXLIWXEVXSJIEGLQERSIYZVI
ACTIVE. The light remains lit for the entire duration of the manoeuvre.
To Next Page
Loading...
