Roger Technology B70/2DC/BOX - Password protection

EN
55
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (&3=), parameters may be viewed, but the values CANNOT be modi
ƼIH
Only a single password is used to control access to the gate automation system.
WARNING: Contact the Technical Support Service if you lose your password.
3  
3 
3 
3 
Password activation procedure:
• Enter the desired values for parameters 3, 3, 3 and 3.
• Use the UP
a
ERHSV(3;2
b buttons to view the parameter &3.
• Press and hold the
ERHFYXXSRWJSVWIGSRHW
• 8LIHMWTPE]ƽEWLIWXSGSRƼVQXLEXXLITEWW[SVHLEWFIIRWEZIH
• Switch the control unit off and on again. Check that password protection is activated (&3=).
Temporary unlock procedure:
• Enter the password.
• Check that &3= .
Password cancellation procedure:
• Enter the password (&3=).
• Save the values 3, 3, 3, 3 = 
• Use the UP
a
ERHSV(3;2
b buttons to view the parameter &3.
• Press and hold the + and - buttons for 4 seconds.
• 8LIHMWTPE]ƽEWLIWXSGSRƼVQXLEXXLITEWW[SVHLEWFIIRGERGIPPIHXLIZEPYIW3 ,3 ,3 
and 3  indicate that no password is set).
• Switch the control unit off and on again (&3=).
&3 
Changing password

Protection deactivated.

Protection activated.