EN
12
of two panels (PAN1, PAN2) so in case of double installation use both.
When installing two panels, always use panels with the same characteristics
and power.
ETICHETTA
LABEL
NERO
BLACK
ROSSO
RED
DIODO DI BY-PASS
BY-PASS DIODE
CATODO
CATHODE
Wiring length Recommended cable
Up to 5m 2x1,5mm
2
Up to 10m 2x2,5mm
2
10 to 20m 2x4mm
2
For further information, refer to the installation manual of the B71/
PBX.
6 Maintenance
Perform scheduled maintenance every 6 months.
Clean the panel to maintain its eciency. Check the condition of the connection
cables and replace them if necessary.
7 Disposal
This product may only be uninstalled by qualied technical personnel,
following suitable procedures for removing the product correctly and
safely. This product consists of numerous different materials. Some of
these materials may be recycled, while others must be disposed of correctly at
the specic recycling or waste management facilities indicated by local
legislation applicable for this category of product. Do not dispose of this product
as domestic refuse. Observe local legislation for differentiated refuse collection,
or hand the product over to the vendor when purchasing an equivalent new
product.
Local legislation may envisage severe nes for the incorrect disposal of this
product.
Warning! Some parts of this product may contain substances that are harmful
To Next Page
Loading...