Roger Select - User Manual

To Next Page

This information sheet is provided as a reference in consultation

with your local Visiting Teacher.

How to Connect the Roger Select

Microphone/Transmitter

The Roger Select must be fully charged before use. Charge for three hours minimum.

 To turn on the microphone, press on/off button, hold for three seconds

 When the microphone is switched on, the status light around the on/off button will

blink

 A green blinking light means battery is fully charged

 An orange blinking light means battery is half full

 A red blinking light means battery empty

 A blue blinking light means the device is connecting

Connecting the microphone to your receivers:

The Roger receiver must be attached to the hearing aid or cochlear processor

 Turn on the microphone

 Place the Roger microphone within 4cm from the Roger receiver.

 Press the connect icon/ button on the back of the Roger microphone. Press once and

let go. The back indicator light will turn green for two seconds to indicate the

connection was successful.

On/Off button

Microphones

/centre lights

Microphone

indicator lights

Centre touch key

Need help?

Do you have a question about the Roger Select and is the answer not in the manual?

Summary

Roger Select Microphone;Transmitter Setup Guide

Charging and Powering On

Covers initial charging duration and steps to power on the microphone, including status light indicators.

Connecting to Receivers

Details the procedure for pairing the Roger Select microphone with hearing aids or cochlear processors.

Roger Select Controls and Indicators

Back Controls and Receiver Compatibility

Identifies the connect button and shows compatible Roger receivers for hearing aids and processors.

Understanding Connection Status Lights

Explains the meaning of different colored lights indicating connection status.

Wearing and Using the Roger Select

Attachment Methods

Describes how to attach the microphone using a magnetic clip or lanyard for secure wear.

Microphone Placement

Provides guidance on optimal placement of the microphone near the speaker's mouth.

Testing and Laptop Connectivity

Equipment Functionality Test

Outlines methods to test if the Roger Select microphone is working correctly with a pupil.

Connecting to a Laptop

Explains how to connect the Roger Select to a laptop via audio cable for streaming.