Remote Control
R&S
®
CMW500
158User Manual 1173.9463.02 ─ 02
sub-instrument, not per instrument. That means e.g. that within sub-instrument 1 the
value TX1 refers to another physical TX module than within sub-instrument 2.
The following table lists the supported parameter values and used *RST values for selec-
tion of RF connectors and TX/RX boards.
Sub-Instrument 1 Sub-Instrument 2
Input connector
RF1C | RFAC RF2C | RFAC
Output connector
RF1C | RF1O | RFAC |
RFAO
RF2C | RFAC
Mapping RFAC, RFAO
RF1C, RF1O RF2C, n/a
TX module
TX1 TX1
RX module
RX1 RX1
*RST connectors
RF1C RF2C
*RST TX/RX
TX1, RX1 TX1, RX1
6.4.4.9 Four RF Output Paths, Two Frontends, One Sub-Instrument
This section applies to an instrument with four RF output paths, two RF input paths and
two advanced frontends. It provides four instances for generator applications and two
instances for measurement applications. All resources are grouped in one sub-instru-
ment.
All firmware application instances can access both frontends. The following table lists the
supported parameter values and used *RST values for selection of RF connectors and
TX/RX boards.
Instance 1 Instance 2 Instance 3 Instance 4
Input connector
RF1C | RF2C | RF3C | RF4C | RFAC | RFBC
Output connector
RF1C | RF1O | RF2C | RF3C | RF3O | RF4C | RFAC | RFAO
| RFBC
Mapping RFAC, RFAO, RFBC
RF1C, RF1O, RF2C
TX module TX1, TX3 (for RF1/RF2 connectors only)
TX2, TX4 (for RF3/RF4 connectors only)
RX module RX1 (for RF1/RF2 connectors only)
RX2 (for RF3/RF4 connectors only)
*RST connectors
RF1C RF3C RF2C RF4C
*RST TX/RX
TX1, RX1 TX2, RX2 TX3, n/a TX4, n/a
Control of the Instrument
To Next Page
Loading...
