Rohde & Schwarz CMW500 Series - Page 221

Command Reference
R&S
®
CMW500
221User Manual 1173.9463.02 ─ 02
7.3.7.2 STATus:OPERation (Elementary Commands)
The STATus:OPERation subsystem controls the status reporting structures of the STA-
Tus:OPERation register, see STATus:OPERation.
The commands listed below control all levels of the STATus:OPERation register hierar-
chy. They require the knowledge of the register hierarchy at bit level. For additional com-
mands refer to the following sections:
●
To control the registers based on register names instead of bit numbers, see chap-
ter 7.3.7.3, "STATus:OPERation (Extended Commands)", on page 228.
●
For comfortable overall evaluation of the registers, see chapter 7.3.7.4, "STA-
Tus:OPERation (Overall Evaluation)", on page 235.
The lowest three levels of the STATus:OPERation register hierarchy depend on the
installed firmware applications. The syntax description of the related commands uses the
following variables:
Table 7-1: Variables in STATus:OPERation commands
Variable Description
<netw_std> network standard:
BLUetooth | CDMA | EVDO | GPRF| GSM | LTE | TDSCdma | WCDMa | WIMax | WLAN
<func_grp> function group:
MEASurement<i> | GENerator<i>
with instance <i> = 1 | 2 | 3 | 4
<appl> application:
for GENerator: UNIVersal
for MEASurement: EPSensor | FFTSanalyzer | IQRecorder | IQVSlot | MEValuation |
POWer | PRACh | SRS
Example: if a multi evaluation measurement for GSM is installed at your instrument, this
results in the combination GSM:MEASurement:MEValuation. Command example:
STATus:OPERation:TASK:A:GSM:MEASurement:MEValuation:ENABle?.
All commands related to the highest level (STATus:OPERation) are SCPI-confirmed.
Note that *RST does not influence the status registers (see also Reset Values of the
Status Reporting System).
STATus:OPERation:CONDition.......................................................................................222
STATus:OPERation:TASK:CONDition..............................................................................222
STATus:OPERation:TASK:A:CONDition...........................................................................222
STATus:OPERation:TASK:A:<netw_std>:CONDition.........................................................222
STATus:OPERation:TASK:A:<netw_std>:<func_grp>:CONDition........................................222
STATus:OPERation:TASK:A:<netw_std>:<func_grp>:<appl>:CONDition.............................222
STATus:OPERation:ENABle...........................................................................................223
STATus:OPERation:TASK:ENABle..................................................................................223
STATus:OPERation:TASK:A:ENABle...............................................................................223
STATus:OPERation:TASK:A:<netw_std>:ENABle.............................................................223
STATus:OPERation:TASK:A:<netw_std>:<func_grp>:ENABle............................................223
STATus:OPERation:TASK:A:<netw_std>:<func_grp>:<appl>:ENABle.................................223
STATus:OPERation:ESRQ.............................................................................................223
Instrument-Control Commands