Rohde & Schwarz R&S FSH6 - 2 Getting Started; Measurements on CW Signals; Power and Related Measurements; Receiver Mode Operation

Contents R&S FSH
1145.5973.12 I.2 E-11
2 Getting Started ............................................................................................................................2.1
Measurements on CW Signals........................................................................................................2.1
Level measurement ....................................................................................................................2.1
Setting the Reference Level .......................................................................................................2.2
Frequency Measurements..........................................................................................................2.3
Harmonic Measurements of a Sinewave Signal.........................................................................2.4
Power Measurements Using the Power Sensor ........................................................................2.5
Power and Return Loss Measurements with the R&S FSH-Z14 or the R&S FSH-Z44.............2.7
Two-Port Transmission Measurements......................................................................................2.9
Measurement of Return Loss .................................................................................................. 2.11
Performing Distance-To-Fault Measurements ........................................................................ 2.14
Operation in Receiver Mode......................................................................................................... 2.20
Measuring the Carrier-to-Noise Ratio ......................................................................................... 2.25
Reference power/reference level ............................................................................................ 2.26
Measuring the noise power ..................................................................................................... 2.27
Saving and Recalling Settings and Test Results....................................................................... 2.28
Saving Measurement Results.................................................................................................. 2.28
Saving Calibration Data........................................................................................................... 2.29
Recalling Measurement Results.............................................................................................. 2.30
Printing Out Measurement Results ............................................................................................. 2.31