EasyManua.ls Logo

Rohde & Schwarz NRP2 - User Manual

Rohde & Schwarz NRP2
419 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
NRP2 Power
Meter User
Manual
1173.9140.02 ─ 07
(;×éX2)
北京海洋兴业科技股份有限公司(证券代码:839145)
电话:010-62176775
网址:www.hyxyyq.com

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Rohde & Schwarz NRP2 and is the answer not in the manual?

Rohde & Schwarz NRP2 Specifications

General IconGeneral
BrandRohde & Schwarz
ModelNRP2
CategoryMeasuring Instruments
LanguageEnglish

Summary

Basic Safety Instructions

Electrical safety

Provides essential information on electrical safety to prevent hazards like electric shock or fire.

1 Putting into Operation

1.1 Notes on putting into operation

Provides crucial notes and precautions before operating the R&S NRP2 for the first time.

1.7 Connecting the instrument to the AC supply

Explains how to connect the R&S NRP2 to the AC power source, including safety notes.

1.8 Starting the R&S NRP2

Describes the procedure for switching the instrument on and initiating its startup sequence.

2 Getting Started

2.3 Preset and zeroing

Guides on setting the R&S NRP2 and sensors to a defined initial state and performing zero calibration.

2.4 Measuring average power (Cont Av mode)

Demonstrates standard power measurement using the R&S NRP2 in Continuous Average (Cont Av) mode.

2.7 Graphically representing power versus time

Details how to represent power versus time graphically using the "Trace & Statistics" mode.

2.8 Measuring average burst power (Burst Av mode)

Explains how to perform burst-average power measurements with pulsed RF signals.

4 Instrument Functions

4.1 Main Settings

Covers accessing main instrument settings via hardkeys, including presets and frequency settings.

4.2 Data acquisition and parameters

Details how to configure data acquisition and parameters using the "Sensor" menu for up to four sensors.

4.3 Displaying measurement results

Explains how to arrange and label measurement windows for displaying results.

4.4 Configuring measurements

Guides on configuring measurements, including selecting channels, functions, and units for display.

4.5 Displaying traces

Covers graphically displaying envelope power versus time or amplitude distribution using many sensors.

4.6 Management of settings

Covers managing general instrument settings via the File menu, including defaults and user-defined setups.

4.7 System settings

Covers configuring system settings, including remote control interfaces, analog outputs, and system information.

5 Remote Control Fundamentals

6 Remote Control - Commands

6.4 High-Level Measurement Commands (CONFigure, MEASure, READ and FETCh)

Introduces high-level commands that simplify measurement configuration and execution.

6.11 SENSe (Sensor Commands)

Covers configuring power sensors, measurement modes, offset corrections, and filter settings.

7 Maintenance

8 Error Messages and Troubleshooting

8.2 SCPI-Specific Error Messages

Lists SCPI error messages, categorized by error code, text, and explanation.

A Annex

A.4 Programming Measurements

Guides on programming measurements using high-level and low-level commands, including trigger and sensor settings.

Related product manuals