Annex
NRP2
354User Manual 1173.9140.02 ─ 07
3. Enable the "Volatile Mode" setting.
The Volatile Mode is activated. The current setting is used after each power on.
You can also reset the R&S NRP2 to factory default by erasing the nonvolatile mem-
ory.
A.1.2
Changing the Password
►
To change the password open the "Change Password" menu and enter the new
password.
A.2 Remote control interfaces
This section covers hardware related topics on the remote control interfaces, like pin
assignment of the GPIB bus interface.
For information on how to set up a remote control connection via the different interfa-
ces, see chapter 5.2, "Connecting a Controller to the Base Unit", on page 170
.
For information on how to configure the interfaces, see chapter 4.7.1, "Configuring the
remote control interfaces",
on page 145.
All other hardware interfaces are described in chapter 1.6, "Rear Panel Tour",
on page 15
Remote control interfaces
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
