Rohde & Schwarz NRP2 - Table of Contents

Remote Control - Commands
NRP2
195User Manual 1173.9140.02 ─ 07
refer to the status reporting system which is described in detail in chapter 6.13, "STA-
Tus", on page 296.
Commands available in the R&S
NRP2
*CLS.............................................................................................................................195
*ESE.............................................................................................................................195
*ESR?...........................................................................................................................196
*IDN?............................................................................................................................196
*IST?............................................................................................................................ 196
*OPC............................................................................................................................196
*OPT?...........................................................................................................................197
*PRE............................................................................................................................ 197
*PSC............................................................................................................................ 197
*RCL.............................................................................................................................198
*RST.............................................................................................................................198
*SAV ............................................................................................................................204
*SRE............................................................................................................................ 204
*STB?...........................................................................................................................205
*TRG............................................................................................................................ 205
*TST?........................................................................................................................... 205
*WAI.............................................................................................................................205
*CLS
CLear Status resets the
●
status byte (STB)
●
standard event register (ESR)
●
EVENt part of the QUEStionable and the OPERation register
●
Error / event queue
The command does not alter the ENABle and TRANsition parts of the registers.
Usage: Event
*ESE <value>
Setting command: *ESE
Event Status Enable sets the event status enable register to the specified value.
Query: *ESE?
The query form *ESE? returns the contents of the event status enable register in deci-
mal form.
Parameters:
<Value> 0 to 255
Common Commands to IEEE 488.2
北京海洋兴业科技股份有限公司（证券代码：839145）
电话：010-62176775
网址：www.hyxyyq.com