Annex
NRP2
401User Manual 1173.9140.02 ─ 07
TRIG:DEL:AUTO OFF 'no delay on triggering
CALC1:MATH "(SENS1)" 'only uses the first CALCulate block
CALC2:MATH "(SENS2)"
CALC3:MATH "(SENS2)"
CALC4:MATH "(SENS2)"
CALC5:MATH "(SENS2)"
CALC6:MATH "(SENS2)"
CALC7:MATH "(SENS2)"
CALC8:MATH "(SENS2)"
A.5 Compatibility Information
This section contains information regarding the compatibility of the R&S
NRP2 remote
control commands with those of the "E4418B" and "E4419B" power meters from Agi-
lent. The R&S NRP2 is largely downward-compatible to the above-mentioned instru-
ments but offers additional capabilities.
E4418B/E4419B command Compatibility information
CONFigure?
Returns the current configuration. The R&S NRP2 returns the last
setting made with CONFigure, as specified by the SCPI standard.
CALCulate:GAIN SENS:CORR:OFFS:STAT
CALCulate:PHOLd
Is implemented in the R&S NRP2 and has the same effect as
CALC:
EXTR:RES.
CALibration
:ECONtrol
:RCALibration
:RFACtor
Is not implemented in the R&S NRP2.
DISPlay:ENABle[?]
Is implemented in theR&S NRP2 and has the same effect as
DISPlay:
ILLUmination.
DISPlay:
SCREen:FORMat
[:NUMeric[1]|2]
Is not implemented in the R&S NRP2.
INITiate
:CONTinuous:SEQUence[1]|2
:IMMediate:
SEQUence[1]|2
The :SEQUence node is not implemented in the R&S NRP2.
MEMory:TABLe:GAIN
Agilent specifies the values without a unit; the unit PCT (percent) is
implicitly assumed. The units DB (dB), DPCT (Δ%) and O (unit 1)
can be specified in the R&S NRP2. The default unit is DB.
OUTPut:TRIGger:STATe
Is not implemented in the R&S NRP2.
Compatibility Information
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
