Rohde & Schwarz RTA4000 - Page 550

Remote control commands
R&S
®
RTA4000
550User Manual 1335.7898.02 ─ 08
Usage: Event
SPECtrum:SPECtrogram:SCALe <LinesPerAcquisition>
Defines a zoom factor for the spectrogram.
Parameters:
<LinesPerAcquisition>Range: 1 to 20
Increment: 1
*RST: 1
DISPlay:CBAR:SPECtrogram[:POSition] <DividerPosition>
Defines the position of the divide bar on top of the spectrogram.
Parameters:
<DividerPosition> Vertical position in pixel, measured from the top edge. The verti-
cal display size is 800 px.
Default unit: px
17.8.4.2 Peak list settings
SPECtrum:MARKer:RTABle:ENABle................................................................................550
SPECtrum:MARKer[:ENABle]..........................................................................................550
SPECtrum:MARKer:SOURce.......................................................................................... 551
SPECtrum:MARKer:SETup:MMODe................................................................................ 551
SPECtrum:MARKer:SETup:MLEVel................................................................................. 551
SPECtrum:MARKer:SETup:DISTance.............................................................................. 551
SPECtrum:MARKer:SETup:EXCursion.............................................................................551
SPECtrum:MARKer:SETup:MWIDth.................................................................................551
SPECtrum:MARKer:REFerence:SETup:CMPeak...............................................................552
SPECtrum:MARKer:REFerence:SETup:CSCReen............................................................ 552
SPECtrum:MARKer:RTABle:ENABle <ResultTable>
Shows the peak list.
Parameters:
<ResultTable> ON | OFF
*RST: OFF
SPECtrum:MARKer[:ENABle]
Enables the usage of markers.
Parameters:
<MarkerEnable> ON | OFF
Applications