Rohde & Schwarz RTA4000 - Page 600

Remote control commands
R&S
®
RTA4000
600User Manual 1335.7898.02 ─ 08
SYSTem:COMMunicate:INTerface:ETHernet:DHCP.......................................................... 600
SYSTem:COMMunicate:INTerface:ETHernet:IPADdress.................................................... 600
SYSTem:COMMunicate:INTerface:ETHernet:SUBNet........................................................600
SYSTem:COMMunicate:INTerface:ETHernet:GATeway......................................................600
SYSTem:COMMunicate:INTerface:ETHernet:IPPort...........................................................600
SYSTem:COMMunicate:INTerface:ETHernet:VXIPort........................................................ 601
SYSTem:COMMunicate:INTerface:ETHernet:HTTPport......................................................601
SYSTem:COMMunicate:INTerface:ETHernet:TRANsfer..................................................... 601
SYSTem:COMMunicate:INTerface:ETHernet:MACaddress?............................................... 601
SYSTem:COMMunicate:INTerface:ETHernet:DHCP
Enables DHCP for automatic network parameter distribution.
Parameters:
<DHCP> ON | OFF
OFF
Use the following commands to specify connection parameters:
SYSTem:COMMunicate:INTerface:ETHernet:IPADdress
on page 600
SYSTem:COMMunicate:INTerface:ETHernet:SUBNet
on page 600
SYSTem:COMMunicate:INTerface:ETHernet:GATeway
on page 600
SYSTem:COMMunicate:INTerface:ETHernet:IPADdress
SYSTem:COMMunicate:INTerface:ETHernet:SUBNet
SYSTem:COMMunicate:INTerface:ETHernet:GATeway
Return or specify.
●
IP address of the instrument.
●
IP subnet mask used by the instrument.
●
IP gateway used by the instrument.
Parameters:
<FirstByte> Range: 0 to 255
Increment: 1
<SecondByte> Range: 0 to 255
Increment: 1
<ThirdByte> Range: 0 to 255
Increment: 1
<FourthByte> Range: 0 to 255
Increment: 1
SYSTem:COMMunicate:INTerface:ETHernet:IPPort <IPPort>
Returns or specifies the IP port number (default = 5025).
General instrument setup