Trying Out the Instrument
R&S
®
RTE
51Getting Started 1326.1026.02 ─ 08
5. To save space in the display, minimize the result box. The most important
results are displayed and updated in the result icon, as well.
6. To remove the result icon and make room on the display for other results, tap
the red cross on the icon label.
5.6.2 Performing Automatic Amplitude Measurements
You can start up to 8 automatic measurements to run in parallel. The "Automatic
measurment"
icon starts the measurements one after the other.
In the following example you start and configure 3 automatic measurements:
amplitude, rise time, and fall time measurement, and you display the statistical
evaluation.
1. Restore the default signal channel settings by pressing the [PRESET] and
[AUTOSET] keys.
Showing Basic Measurement Results
To Next Page
Loading...
