Rohde & Schwarz RTE Series - Page 52

Trying Out the Instrument
R&S
®
RTE
52Getting Started 1326.1026.02 ─ 08
2. Tap the "Automatic measurment" icon. Then tap the waveform.
By default, the measurement of the high signal level is started.
3.
Tap the "Automatic measurement" icon again. Then tap the waveform.
By default, the measurement of the low signal level is started.
4. Tap the "Automatic measurement" icon again. Then tap the waveform.
By default, the amplitude measurement is started.
5. Double-tap the results to open the "Measurements" dialog box.
In the "Setup" tab, you see the activated measurements and the assigned
measurement types.
6.
In the "Meas1" line, tap the measurement type button labeled "High".
7. Select "Rise time".
8. In the "Meas2" line, tap the measurement type button labeled "Low".
Showing Basic Measurement Results
www.allice.de
Allice Messtechnik GmbH