Rohr MIG-135A - Environment; Technical Data

MIG-135A / MIG-150R
© Röhr
8
© Röhr
Environment
1. The machine can perform in environments where conditions are dry with a maximum
humidity level of 90% and an ambient temperature between -10 to +40 degrees centigrade.
2. Avoid welding in direct sunshine or a wet/damp environment. If the machine comes into
contact with water, do not use the machine until it has been fully inspected by a qualied
professional.
3. Do not use the machine in an environment where the air is polluted with conductive dust.
Health and Safety
Technical Data
MIG-135A MIG-150R
Power Input Single Phase AC230V±15% Single Phase AC230V±15%
Frequency (HZ) 50/60 50/60
Rated Input Current (A) 23 25
Output Current MIG (A) 40-135 60-150
Output Voltage 16.5-20.5 16.9-21.5
Duty Cycle (%) 60 60
Power Factor 0.93 0.93
Efciency (%) 85 85
Wire Spool Compact Compact
Wire Speed (M/Min) 2.5-13 2.5-13
Post Puff (S) 1 1
Wire Wheel Diameter (mm) 150 150
Wire Diameter (mm) 0.6-0.8 0.6-0.8
Housing Shielding Grade IP21 IP21
Insulation Grade H H
Suitable Wire Thickness 0.8 and above 0.8 and above