a. Install RR (rear) Shocks and tighten the nuts.
b. Install Ball Head, Tie Rod, tighten the Castle Nut and insert the cotter Pin.
c. Install Front Tires and tighten the nuts
d. Install Rear Tires, tighten the nuts and insert cotter Pin.
e. Put the protection pole cover on the frame as what picture shows
f. Install the bolts and washers, then tighten the nuts.
g. Install the two scats, Fix them in place with bolts and nuts from the bottom of the
frame.
h. Fill the fuel tank with Unleaded Gasoline and turn on the ignition switch to start the
engine.
P. D .I .
To Next Page
Loading...
