SERVICE INSTRUCTIONS/ REPAIR
1. Adjustment of Front And Rear Shock
There are many adjustable positions on each shock The default position
is in the middle set by manufacture (Sec picture 11),
Use a round nut wrench as you adjust the shock. The tension of shock
spring will increase as you screw clockwise, decrease as you screw counter-
clockwise.
2. Storage Instructions
In the event your kart is not to be operated for periods in excess of 30
days or at the end of each driving season prepare for storage as follows.
Drain fuel tank and carburetor by allowing engine to run out of fuel,
or use a fuel stabilizer.
Lubricate engine cylinder by removing the spark plug and pour one
ounce of clean lubricating oil through the spark plug hole into the
cylinder. Crank the engine slowly to spread oil and replace spark
plug.
Do not save or store gasoline over winter. Using old gasoline, which
has deteriorated from storage, will cause hard starting and affect
engine performance.
REPAIR
1. Front Wheel Replacement
Do not disassemble the castle nuts when you
replace the front wheels.
It is only necessary to tighten the nuts so that the
wheel turns freely on the axle with minimum end play.
(See picture 12) Tighten the nuts after replacing the
wheels.
To Next Page
Loading...
