MFX/IFX Parameters
50
26 HEXA-CHORUS
Uses a six-phase chorus (six layers of chorused sound) to give
richness and spatial spread to the sound.
R out
L out
Balance W
Balance W
Balance D
Balance D
L in
R in
Parameter Value Explanation
Pre Delay 0.0–100 [msec]
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate Sync
(Rate (sync switch))
OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
& “Tempo” (p. 8)
Rate Hz (Rate (Hz)) 0.05–10.00 [Hz]
Frequency of modulation
Rate Note
(Rate (note))
Note
& “Note” (p. 72)
Depth 0–127 Depth of modulation
Pre Delay Dev
(Pre Delay Deviation)
0–20
Adjusts the differences in Pre Delay
between each chorus sound.
Depth Dev
(Depth Deviation)
-40
Adjusts the difference in modulation
depth between each chorus sound.
Pan Dev
(Pan Deviation)
-20–+20
Adjusts the difference in stereo location
between each chorus sound.
0: All chorus sounds will be in the center.
20: Each chorus sound will be spaced at
60 degree intervals relative to the center.
Balance
D100: 0W–D0:
100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level
27 TREMOLO CHORUS
This is a chorus effect with added Tremolo (cyclic modulation of
volume).
R out
L out
Balance W
Balance W
Balance D
Balance D
L in
Tremolo
Chorus
Tremolo
Chorus
R in
Parameter Value Explanation
Pre Delay 0.0–100 [msec]
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Cho Sync (Chorus Rate
(sync switch))
OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
& “Tempo” (p. 8)
Cho Hz
(Chorus Rate (Hz))
0.05–10.00 [Hz]
Modulation frequency of the chorus
effect
Cho Note
(Chorus Rate (note))
Note
& “Note” (p. 72)
CHO_DEPTH
(Chorus Depth)
0–127 Modulation depth of the chorus effect
Trm Sync
(Tremolo
Rate (sync switch))
OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
& “Tempo” (p. 8)
Trm Hz
(Tremolo Rate (Hz))
0.05–10.00 [Hz]
Modulation frequency of the tremolo
effect
Trm Note
(Tremolo Rate (note))
Note
& “Note” (p. 72)
Trm Separate
(Tremolo Separation)
0–127 Spread of the tremolo effect
Trm Phase
(Tremolo Phase)
0–180 [deg] Spread of the tremolo effect
Parameter Value Explanation
Balance
D100: 0W–D0:
100W
Volume balance between the direct
sound (D) and the tremolo chorus sound
(W)
Level 0–127 Output Level
28 SPACE-D
This is a multiple chorus that applies two-phase modulation in
stereo. It gives no impression of modulation, but produces a
transparent chorus effect.
R out
L out
Balance W
Balance W
Balance D
Balance D
L in
R in
Parameter Value Explanation
Pre Delay 0.0–100 [msec]
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate Sync
(Rate (sync switch))
OFF, ON
If this is ON, the rate synchronizes with
the tempo of the rhythm.
& “Tempo” (p. 8)
Rate Hz (Rate (Hz)) 0.05–10.00 [Hz]
Frequency of modulation
Rate Note
(Rate (note))
Note
& “Note” (p. 72)
Depth 0–127 Depth of modulation
Phase 0–180 [deg] Spatial spread of the sound
Low Gain -15–+15 [dB]
Amount of boost/cut for the low-
frequency range
High Gain -15–+15 [dB]
Amount of boost/cut for the high-
frequency range
Balance
D100: 0W–D0:
100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level
29 OVERDRIVE
This is an overdrive that provides heavy distortion.
L in
R in
L out
R out
Pan L
Pan R
Parameter Value Explanation
Drive 0–127
Degree of distortion
Also changes the volume.
Tone 0–127 Sound quality of the Overdrive effect
Amp Switch OFF, ON Turns the Amp Simulator on/off.
AmpType
(Amp Type)
SMALL,
BUILT-IN, 2-STACK,
3-STACK
Type of guitar amp
SMALL: Small amp
BUILT-IN: Single-unit type amp
2-STACK: Large double stack amp
3-STACK: Large triple stack amp
Low Gain -15–+15 [dB]
Amount of boost/cut for the low-
frequency range
High Gain -15–+15 [dB]
Amount of boost/cut for the high-
frequency range
Pan L64–63R Stereo location of the output sound
Level 0–127 Output Level
To Next Page
Loading...
Need help?
General
