Need help?Do you have a question about the Roland Cube-60 Bass and is the answer not in the manual?
General| Type | Bass Amplifier |
|---|---|
| Power Output | 60 Watts |
| Speaker Size | 12 inches |
| Number of Channels | 1 |
| EQ | 3-band EQ |
| Effects | Chorus |
| Outputs | Line Out, Recording/Headphones Out |
| Dimensions | 18.5 x 18.5 x 10.2 inches |
| Weight | 30.9 lbs |
Connects to other amplifiers for boosted power, allowing parallel drive.
Connects another amplifier to emphasize bass frequencies, balancing with the main amp.
Links to other guitar amplifiers, PA mixers, or tape decks for effects or recording.
Connects effects units between the pre-out and main-in jacks for signal processing.
Allows stereo or monaural headphone listening without speaker output.
Connects an 8 ohm or over external speaker system for wider sound spread.
Turns the unit on and off; check plug connection for noise issues.
Selects input level (high/low) based on guitar output for optimal signal.
Adjusts the overall sound output level by turning clockwise to increase.
Adjusts high-frequency response; turn clockwise to boost, counter-clockwise to cut.
Adjusts mid-frequency response; turn clockwise to boost, counter-clockwise to cut.
Adjusts low-frequency response; turn clockwise to boost, counter-clockwise to cut.
Indicates unit status when power switch is set to ON.
To Next Page