Using the Looper
24
Using the Looper in Sync with External Device Clocks
Recording audio input
1.
Press the [â/ó] (play/record) button.
The unit enters record standby mode, and “rEC” blinks in the display.
Recording starts when the next clock is inputted.
During recording or overdubbing, “rEC” is displayed and the [â/ó] (play/record) button lights up red.
2.
To finish the recording, press the [â/ó] (play/record) button again.
“PLAY” blinks in the display and the unit enters record stop mode.
Recording stops when the next clock is inputted, and playback automatically begins.
During playback, “PLAY” is displayed, and the [â/ó] (play/record) button lights up green.
* If a device is connected to the SYNC IN jack, press the [â/ó] (play/record) button to begin recording.
* If a device is connected to the MIDI jacks or to the USB port (for USB MIDI), the unit begins synchronization when a MIDI start
message (FA) is received.
To Next Page
Loading...
