Roland E-4 - Page 36

Setting the Menu
36
Item
Controller
Value
Explanation
MIDI CLOCK
SYNC
[REVERB] slider
Avto, Int,
NIDI, USB
(Auto, Int., MIDI,
USB)
Sets which synchronization signal is used by this unit.
Avto (Auto): Inputted clocks are accepted.
Int (Int): The unit operates according to its internal clock.
NIDI (MIDI): Only MIDI input is accepted.
USB (USB): Only USB MIDI input is accepted.
* Note that when an external device is connected to the SYNC
IN jack, the unit always synchronizes to the clocks that are
inputted to the SYNC IN jack.
*1: When using with another port besides the USB HOST 3 port on the MX-1, the unit starts up in battery-only mode. To use
battery-only mode, turn on the power while holding down the [C] button.
MIDI settings
Function
MIDI
messages
Explanation
ROBOT
NOTE
Note On/Off
Controls the vocoder pitch using note numbers. The [AUTO PITCH] button blinks when notes are
being input.
When the [HARMONY] button is lit, a maximum of four chords can be controlled.
PITCH
Pitch Bend
Controls the [PITCH] slider value.
SYNC
Timing Clock
Controls the looper that synchronizes with the tempo data.
Press the [â/ó (play/record)] and [ð (stop)] buttons to schedule playback and recording. The playing
back or recording starts when the dot in the bottom right of the display lights up.
Set this timing with the SYNC RATE in system setting.