E-600
July, 1999
12. FDD check
The following display will appear:
To make this test you need 3,5" disks (HD or DD kind), formatted by E-600.
Note: When you make this test, the data contained in the floppy disk will be damaged.
Insert a 2DD floppy disk, which is write protected and check that the note "2DD Protected" will appear on the
display. Then insert an unprotected 2DD floppy disk and check that the note "2DD:OK" will appear on the
display. In the same way, insert an unprotected 2HD floppy disk and check that the note "2HD:OK" will appear
on the display.
When you insert an unformatted disk the note "Unformatted" will appear on the display
If there are some problems, the writing "NG". will appear on the display.
When this test is completed, touch "Next" on the screen or press the Part Balance [Accomp] button to go on
to the following test.
13. LCD Check
The following display will appear:
Press the One Touch Program [Piano] button and make sure that all the LCD dots lighten (White).
Then press the One Touch Program [Arranger] button and be sure that all the LCD dots turn off (Blue).
After this, press the Part Balance [Accomp] button. The following display will appear:
Notice if the vertical lines are shown clearly.
Then press the following buttons and verify the ON and OFF conditions of the display:
One Touch Program [Piano] : ON ( LCD with lines )
One Touch Program [Arranger] : OFF ( LCD Blue )
At the end of this test, press the Part Balance [Accomp]button to go to the following check
14. LCD Contrast test
The following display will appear:
Rotate the encoder completely and make sure that the number indicated on the dispaly changes from 0 to
9 and that the contrast changes according to the value indicated. Make also sure that the character is
recognizable even at value "0".
At the end of this test, touch "Next" on the screen or press the Part Balance [Accomp] button so as to go
to the following verification.
15. Destination setup
The following display will appear:
Touch the button corresponding to the destination indicated on the Touch Panel or press the corresponding
button, as follows:
Display Destination Button
DOM 100V One Touch Program [Piano]
EXP 230V/240V One Touch Program [Organ]
US 117V One Touch Program [Arranger]
Then touch "Write" on the screen or press the Part Balance [Accomp] button to start the destination setup.
When the setup ends, you will go automatically to the following step.
The following display will appear:
Turn off the instrument to exit the test mode.
20
To Next Page
Loading...
