Roland E-600 - Page 21

E-600
July, 1999
16. Audio Test
When you turn on the instrument while pressing the buttons "Intro / Ending" 1 and 2 you enter Audio Test.
The display will visualize:
You will hear a sine sound going out from both right and left loudspeakers. The " Volume" potentiometer must
be in Max position.
Calibrate the trimmers of the amplifier channels (P1 c.dx and P2 c. sx) so as the tension at the loudspeakers
is 8,2 Vpp.
Turn off the instrument to exit Audio Test.
How to update the Flash Memory
Since E-600 has a Flash Memory for the recording of the Main Program, you can update it by floppy disk.
GG
Items required:
E-600 VERSION UP DISK (code:7711211000)
After inserting the disk in the FDD, turn on the instrument while pressing the [Start/Stop] and [Metronome] but-
tons contemporarily.
All the LEDs flash and the loading of the program begins.
When the loading ends, the writing "Finished" will appear on the display.
21